 README
 aMixer 1.3
 29-March-1997


Changes from 1.2
----------------
Set all knobs to the non-dot type, for now.

Main window position get repositioned as expected, not just Detail.

During -config (or no existing amixer.ini), if an SB16 then both low and
high DMA channels had to be specified -- now you can select only a low
(or only high, but not recommended), or you can leave it, and IRQ, blank;
only the base port needs to be specified.

Updated Paradise driver to 1.52 (required for the DMA/IRQ change above).


Changes from 1.1
----------------
Added minimize startup option.

Added main/detail window position save.

New switches: -min, -nolp, -nosp

Main volume, balance, and tone controls can operate with Detail window.

Updated Paradise driver to 1.51 (optional, but recommended, esp. for tmidi).


Changes from 1.0
----------------
The minimum active SyncLock rate is now 32ms, rather than 33ms since
33ms was effectively 64ms.

The main control panel was not updated after a Load/Startup/Reset selected
from the Detail control panel.


aMixer 1.0
----------
Paradise 1.5 has new features that are not supported in previous versions.
It is backward compatible with previous versions so you can still use
tmidi 1.5 and tmixer 1.2 with this new driver.

Paradise 1.5 changed the interpretartion of the AGC:  when AGC=1 (on, or
checked), the AGC limiter circuit is active; when AGC=0 (off, unchecked),
the +20dB fixed gain is used.  AGC applies only to the mic input.

Previous versions of Paradise did not set the Mic level for the 1345 (SB Pro)
mixer.

If you have registered tMixer and would like a free upgrade to aMixer, write
to support@40th.com requesting the free upgrade.

